diff --git a/README.md b/README.md
index 8c7e1e0..c57ef17 100644
--- a/README.md
+++ b/README.md
@@ -258,7 +258,7 @@ Select Filesystem to be used (Ext4 / Btrfs).
 
 - If 'Ext4' is selected: 
 
-You will be asked if you'd like a seperate '/home' partition to be created.
+You will be asked if you'd like a seperate '/home' partition to be created/used.
 
 NOTE: The installer supports using an existing (unencrypted) /Home partition.
 
@@ -528,8 +528,6 @@ If the Sanity Check fails, the installer will smartly load any necessary stages,
 
 Choose if you will enable LUKS encryption on your 'Swap/Root/Home' partitions
 
-Also, you will be asked to Label your partitions.
-
 Again, the scope here is not to create an inpenetrable system (FDE) but a typical decently protected system.
 
 Using 'Secure Boot' with an unencrypted 'EFI System Partition' and a LUKS encrypted 'Root/Home/Swap' partition(s) should suffice for most use cases.
@@ -546,12 +544,10 @@ If you chose to create a 'Swap' partition, now it will be activated.
 
 The installer asks the user to select the preferred disk preparation mode:
 
-- [ ] 'Auto' will perform Formatting, Labeling and Mounting of all of the involved partitions automatically, but it will ask for your confirmation before formatting a separate ext4 'Home' partition (if found), in case you would like to keep it intact.
+- [ ] 'Auto' will perform Formatting, Labeling and Mounting of all of the involved partitions automatically.
 
 - [ ] 'Manual' mode will perform the above by asking the user to select which partitions to format, choose desired name to label the partitions, and mount them accordingly.
 
-If using an existing /Home partition is desired, select 'Manual Mode', follow the prompts and skip formatting the /Home partition.
-
 The 'Auto' mode will switch to 'Manual' mode if errors are encountered (so the user gets control of the procedure), and when the said mini-step is completed (e.g formatting 'EFI') it will continue in 'Auto' mode for the rest of the partitions.
 
 Upon completion, both 'Auto' and 'Manual' mode present the user with a (TUI) summary of the partitions and mounts layout, preparing for the next step.
@@ -580,15 +576,15 @@ You will have to re-run the installer.
 If you select to encrypt your system with LUKS, then:
 
 
-- [] Your selected 'Root x86-64' partition will be encrypted.
+- [ ] Your selected 'Root x86-64' partition will be encrypted.
 
-- [] If a separate 'Home' partition has been set to be created, it will be encrypted.
+- [ ] If a separate 'Home' partition has been set to be created, it will be encrypted.
 
 Auto-configuration will take place, and said volume will be unlocked automatically.
 
-- [] If a separate 'Home' partition has been set to be re-used by the installer, it will not be encrypted and will be mounted unformatted to the system.
+- [ ] If a separate 'Home' partition has been set to be re-used by the installer, it will not be encrypted and will be mounted unformatted to the system.
 
-- [] If a Swap partition has been selected, it will be encrypted.
+- [ ] If a Swap partition has been selected, it will be encrypted.
 
 This stage cannot offer automatic error-resolving by automatically taking actions such as re-running previous steps of the installation precedure, like [Auto] or [Manual] mode does, as after LUKS encryption has finished, partprobing and informing the kernel about further/new changes requires a system restart.